Wilson Glass

LAGUNA Wood Door Stainless Steel Exposed Roller Kit
$540.00
with Laguna Rollers and Rally Wall Mount Brackets

Shows the older container bolts. We are now shipping the new stainless bolt shown at right.	The Container Bolts (aka Sex Bolts) are here. We had these manufactured and they came out very nice. The threads are 8 mm and run the length of the cylinder so the bolt can be cut off for thinner doors. The bolt is the right length for 1 1/4" to 1 3/4" thick wood doors. The left end in the picture is the Laguna Bolt so if you have wood and glass the systems will match. You will need a specilaized wrench to tighten the bolts. See bottom of this page. See also Rally Hardware Rally Wood Door Roller YM-21 (with Anti-Rocking Pin) Rally Single Roller YM-00 for Wood or Glass Rally YM-02 for Glass or Wood (Includes Anti-Rocking Pin)
	1 - YM-HG-03 Bottom guide for Wood Doors. Not ball bearing but it is a roller and made from stainless steel.
	5 - Rally Wall Mount Bracket brings the track 3/8" further into the room than the Laguna Wall Mount Bracket.
	2 - Stops for Top track.

You will need a wrench to tighten the Bolts. Click the picture to buy these. We would include this in the kit but you only need one wrench for all the doors you are buying.	SW19 - $32.45 - (This works really well for welding grinders.) LSSW-1 - $42.90
	You can't mount the hardware directly on drywall. If the drywall crushes, then the hanger will tilt and the roller will hit the hanger. If you install two wood screws into the drywall so that the heads are flush with the drywall, then the weight of the doors and stainless steel will not crush the drywall. Possibly a better alternative would be to cut a section of closet pole and using a hole saw cut out the drywall and replace it with the section of closet pole which you just cut to the thickness of the drywall. The screw system is easier.